2-29
2
2
2
2
2
Chapter 2 Basic Operation
Stopping a Cutting Operation
(Data Clear)
If you want to stop a cutting operation of the received
data, clear the data.
1
Press the key, and press the
(DATA CLEAR)
in LOCAL.
2
Press the key.
• The reception buffer is cleared, and the present
mode returns to LOCAL..
Removing the Cutter Unit Temporar-
ily
When cutting or printing-with-a-pen job is finished, the
cutter unit is on the platen.
To check the result of cutting (printing-with-a-pen) or to set
a new medium, follow the steps below to remove the
cutter unit from the platen temporarily.
1
Press the key to display the “TEST
CUT” menu.
2
Press the (TEST CUT).
3
Press to select the “CUTTER
HEAD MOVE/RETRACT”, and press the
key.
• The cutter unit moves from on the platen to the
left end of the machine.
• When the coupling unit is connected to the printer
unit, switch the destination to the cutter unit, and
move to move it to the origin position. (Moving the
cutter unit)
Cutting a media
By using the keys on the operation panel, you can cut the
media at any position.
1
In Local, Press .
• It enters into the origin setting mode.
• By pressing [] , feed the media to the cutting
position.
2
Press the key.
• The media is cut.
• When the cutting has been completed, the current
mode returns to LOCAL.
• When clearing the data, the process will not restart
even if you press the [FUNC3] (REMOTE) key.
• After clearing the data, switching to the remote
mode and receiving another data, new data will be
cut.
• Do not perform the data clearance during the data
transmitting.
• Even after performing the data clearance, the
received data is stored in the reception buffer.
To Next Page
Loading...
