3-13
3
2
2
2
Chapter 3 Mchine setting
Setting the Display of Media Residual
Whether the screen displays the remaining amount of a
media is set.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “MEDIA
REMAIN”, and press the key.
3
Press to select ON/OFF.
4
Press the key.
5
Press the key several times to
end the setting.
Setting the Display of Media Detec-
tion
Set the following two items in media detection settings.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “MEDIA
DETECT”, and press the key.
3
Press to select “
MEDIA DETECT
” ,
and press the key.
4
Press to select AUTO/MANUAL.
5
Press the key.
6
Press to select “USE PR
NUMBER QUERY”, and press the
key.
7
Press to select ON/OFF.
8
Press the key.
9
Press the key several times to
end the setting.
Setting a LANGUAGE
You can change the displayed language.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
(>>)
.
3
Press to select “LANGUAGE” ,
and press the key.
4
Press to select language, and
press the key.
5
Press the key several times to
end the setting.
When the media
remaining amount
display is turned to
"ON"
the remaining amount of a media is
displayed in Remote.
(However, when a leaf media is used,
the length of the media to be printed is
displayed.)
When the media
remaining amount
display is turned to
"OFF"
the remaining amount of a media is not
displayed in the Remote.
• The amount of a media that has been fed by the
printing and jog keys is reflected in the remaining
amount of a media.
• The length of a media (initial value of the
remaining amount) is entered when a roll media is
detected.( P.2-13)
• The setting configured here does not become
effective unless media detection is performed after
the setting has been complete.
Setting of Media
Detection
When loading the media, set whether
to detect the media width automatically
(AUTO) or decide the print (or cut)
range manually (MANUAL).
USE PR NUMBER
QUERY
Set whether or not to enter the number
of the pinch rollers you are using during
media detection.
• When using the media that cannot be detected by
the sensor, such as black cutting sheets, set the
media detection setting to "MANUAL".
• If you set the input of the number of pinch rollers
“OFF” in step 8, the pinch roller pressure and the
number of use, that has been set in RasterLink6,
may not match in some cases. Set to “OFF” only
when performing set of pinch roller pressure
( P.2-13) in this machine.
To Next Page
Loading...
