4-7
Chapter 4 Cutting Funcion
4
2
2
(4) OFFSET Y / OFFSET X
Generally the origin will be set at the position shown
below.
However, depending on your application and the work to
be cut, the cutting position may be misaligned to the
same direction. In this case, the location of the origin can
be corrected.
(5) DETECT END KEY START
(6) SENSOR LEVEL
(7) MARK FILL UP
Setting Description
± 15.00mm
Use this to shift the origin position in the X
direction or Y direction.
• If the origin is located out of the available cutting
area, “ERR37 MARK ORG” will be displayed. In
this case, write the registration marks in the area
closer to the center of the media.
Setting Description
ON/OFF
If this is ON, you will be able to detect crop
mark in [END] key.
• If this is set to ON, the registration mark detection
operation may be started by turning the power
OFF.
Setting Description
1 to 7
The bigger the numerical value is, the higher
the sensitivity of the registration mark sensor
becomes.
If it detects the registration mark by mistake,
lower the sensitivity. Generally, use it with the
setting value of “4”.
Setting Description
ON/OFF
Specify the setting as “ON” when using the “Fill
around the register mark” function of FineCut to
detect the printed registration mark.
Create using a registration mark size of 10 mm
or more when filling in around the registration
mark.
To Next Page
Loading...
