4-13
Chapter 4 Cutting Funcion
4
2
2
Make the media without uncut area (OVER CUT function)
By over lapping the start point and the end point arbitrarily, you can make
the media without uncut area. Specify the OVER CUT function (valid/
invalid) and the length of the OVER CUT. If the length of the OVER CUT
is set, when cut starts, cut will be performed from the position to the front
by the specified length and the tool will move up going too far at the end.
Additionally, you can enable the corner cut function to perform overcutting
of corners other than the start and end points.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press to select the “OVER CUT”,
and press the key.
5
Press to select the set value, and
press the key.
• Set value : OFF/ 0.1 to 1.0m
(in 0.1mm increment)
• When you press the [ENTER] key, the setting for
“CORNER CUT” setting will be displayed.
6
Press to select ON/OFF, and
press the key.
7
Press the key several times to
end the setting.
Other SETUP SUB MENU
How to set other convenient functions is explained below. Change the settings according to the types of use.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press several times, and select an
item to set.
• See "List of Settings" to select one.
5
Press the key.
6
Press to select a set value.
• See "List of Settings" to select one.
7
Press the key.
8
Press the key several times to
end the setting.
List of Settings
The setting is as follows when purchasing:
• Setting proper OVER CUT
can reduce uncut area of
start and end point of a
media easy to bend. If too
large value is set, the result
may have a rupture.
• The set value is retained even when the power is
turned "OFF".
Function Name Overview Set Value
Setting the UP SPEED
This is to set the speed of sheet and carriage movement when
the tool is up.
Setting the speed lower makes the sheet misalignment
reduced at the time of long sheet feeding.
5,10,20,30, AUTO (cm/s）
Setting the DUMMY CUT ( P.4-14) the operation of dummy cutting is set. OFF / ON
Setting the SHEET TYPE
*1
*1. If you set “Heavy” for the media setting, the cutting speed will be limited to 20 cm/s.
This is to set the types of sheet according to the sheet you
use.
Standard / Heavy
Setting the ADJ-PRS OFFSET ( P.4-14)
When there is part of a media left uncut at the starting and
ending points, the value is increased.
0 to 3
to 7
To Next Page
Loading...
