4-14
Chapter 4 Cutting Funcion
About Dummy Cutting
This is performed after detecting the media or when
changing the tool type in front of the pinch roller which is
near the both ends from the position of the cutter unit is
placed presently.
Set the dummy cutting function to OFF when you do not
want to damage the media in cutting cut-out characters.
About Cutter Blade Corrected
Pressure Offset
Some part of a media is left uncut because the pressure
applied when the cutter blade touches the media is weak.
When an optional eccentric blade is used, some part of a
media to be cut with the blade's angle being 120 degrees
or less may be left uncut.
This is because the corners are cut with a low pressure
(about 5 g) automatically applied so that the media does
not turn up. Some part of a media may be left uncut
because the blade edge does not rotate
smoothly in its moving direction with the cutting pressure
being low. In such a case, configure the setting for the
pressure to be increased when the corners are cut.
SETUP RESET
Reset the setting values to the initial state.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press several times, and select an
item to set.
• See "List of Settings" to select one.
5
Press
(>>)
and press the twice.
• “SETUP RESET” will be selected.
6
Press the key.
• The already configured settings are initialized.
7
Press the key several times to
end the setting.
• When “PEN” is selected for the tool condition, the
dummy cutting cannot be set.
• The default of the dummy cutting function is
ON.When you have set the dummy cutting
function to OFF, perform test cutting ( P.2-28)
to adjust the cutter blade orientation before
cutting.
To Next Page
Loading...
