4-15
Chapter 4 Cutting Funcion
4
2
2
Maintenance Function
This section gathers together the functions for checking/
adjusting the cutting accuracy when cutting does not go
normally.
Maintenance of Mark Sensor
If cutting does not go normally, check the items below.?
In registration mark sensor maintenance, you can carry
out maintenance of the following items.
Check the sensor for the registration
mark detection
Prepare the media on which the registration mark is
printed.
1
Press in Local.
• Enter the jog mode
2
Press to move the tip of
the pen to the registration mark detection
position
• Perform registration mark detection at a position
1mm or more away from the registration mark.
3
Press the key to terminate the
jog mode.
• The machine returns to the Local.
4
Press the
(MENU)
(>>)
key.
• Cuttibg MENU will be displayed.
5
Press
(>>)
.
6
Press to select the
“MAINTENANCE”, and press the
key.
7
Press to select “MARK
SENSOR”, and press the key.
8
Press to select “SENSOR
CHECK”, and press the key.
9
Select the length of the registration mark
and shape of the registration mark
detection.
• For details on setting the [SIZE] and [FORM],
refer to the ”Setting of Detecting the Registration
Marks”. ( P.4-6)
10
Press the to perform registration
mark detection. ( “Detect operation”)
Function name Outline
MARK sensor
(P.4-15)
Adjusting the registration mark sensor.
SAMPLE CUT
(P.4-17)
In case that normal hanaokadata
cutting cannot be performed etc.,
perform cutting with the sample stored
in this machine to find out the cause of
cutting error.
AUTO MEDIA CUT
(P.4-17)
You can cut a medium into multiple
pieces with a certain length.
PC ORIGIN OFFSET
(P.4-18)
Adjust the misalignment between the
print origin and the cutting origin.
SCAKLE ADJUST
(P.4-19)
When printing and cutting without
registration marks, adjustment is
performed if the misalignment in the
scanning direction occurs between the
left and right edges of the media.
Item Outline
SENSOR CHECK
(P.4-15)
checking the sensor for the register
mark detection.
POINTER OFFSET
(P.4-16)
If the cutter unit fails to recognize any
register mark properly, the possible
cause is an error in the positional
relationship between the mark sensor
and the light pointer. In this case,
correct the position of the light pointer.
• If you move the head and sheet manually, you
cannot perform the right response check. Be sure
to perform it via the following operations.
• For conditions of already printed registration
mark, refer to “Precautions in inputting data with
registration marks” ( P.4-2).
• The setting values are kept in memory even when
the power is turned off.
• The settings performed here for shape of the
registration mark and length of the registration
mark are reflected in the settings of “MARK
DETECT”.( P.4-6)
• The detection speed selected here will be used in
the registration mark detection operations that are
executed from here on.
• The pointer offset value selected by this operation
is not initialized by SETUP RESET operation.
To Next Page
Loading...
