4-17
Chapter 4 Cutting Funcion
4
2
2
Perform SAMPLE CUT to Find out the
Cause of Cutting Error.
In case that normal data cutting cannot be performed etc.,
perform cutting with the sample stored in this machine to
find out the cause of cutting error.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the
“MAINTENANCE”, and press the
key.
4
Press to select the “SAMPLE
CUT”, and press the key.
5
Press to select the SAMPLE
DATA to be cut.
• There are two types of samples, “Cut” and
“Logo.” If you select “Cut,” proceed to Step 7.
6
Press the key.
7
Select scale factor using to cut
Logo.
• Scale factor : 1 to 999%
8
Press the key for starting cutting.
Result of SAMPLE CUT
Sample data can be cut successfully, but other data
cannot.
The host computer is faulty.
Sample data as well as other data cannot be successfully
cut either.(When leaving the start/end lines without cutting
off)
Increase the set value of [ADJ-PRS OFS] to raise the
pressure for pressing the cutter blade down.
Cutting a Medium into Multiple
Pieces with a Certain Length
You can cut a medium into multiple pieces with a specified
length. (Automatic media-cutting function)
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the
“MAINTENANCE”, and press the
key.
4
Press to select the “MEDIA CUT”,
and press the key.
5
Press to select a cutting interval,
and press the key.
• Set value : 10 to 10,000 mm
6
Press to select a length for the
leading end adjustment cutting, and press
the key.
• Set value : 0 to 500 mm
7
Press to select the number of
times a medium is cut (number of pieces
produced by cutting a medium), and press
the key.
• Set value : 1 to 9,999
• The number of cuts that you set here will be
executed.
• You can halt the cutting by pressing the [END/
POWER] key.
8
Press the key several times to
end the setting.
• Execution of SAMPLE CUT will clear the data in
the receiver buffer.
Function name Outline
Cutting interval Setting the interval for cutting the media.
Leading end
adjustment cutting
Setting the length for cutting the medias’
leading edges before auto media cut starts.
With edge match cutting, the specified
number of media sheets can be cut at
equally spaced intervals, even if their
leading edges were previously cut to be
slanted or uneven.
Number of times a
medium is cut
Setting the number of times (sheets) for
media cutting.
To Next Page
Loading...
