Chapter 4 Cutting Funcion
4-18
Cutting out Data without Register Marks (PC ORIGIN OFFSET)
Adjust the misalignment between printing and cutting by Print & Cut.
Print the adjustment pattern from RasterLink6, and enter the adjustment values to the printer.
For Print & Cut without registration marks
1
Set the machine to "REMOTE" status.
2
Set the print conditions (profile, cut conditions) of the job that you want to print using RasterLink6.
3
Click [print & cut Origin adjust] in the [Cut
edit] tab of RasterLink6.
• Click [OK] to print the adjustment pattern.
4
When the pattern is printed, press
(ADJUST) and select "PC ORIGIN OFFSET".
• When the media is fed, peal the cut part of the pattern, and check the adjustment values
5
Enter the adjustment values
• When you press the [ENTER] key, the media return, and the operation is completed.
• When printing the data that has a different resolution (Y), make adjustment again. (Save an adjustment value per
resolution)
• You cannot print adjustment patterns with multiple conditions continuously, and enter the adjustment values. Make sure
you print and set one adjustment value per condition.
X enlarged
Y enlarged
Enter the value of the position that has the
least misalignment between top and bottom
The example here shows that -4 has the least
misalignment, so enter “-4”.
Enter the value of the position that has the
least misalignment between right and left
The example here shows that 2 has the least
misalignment, so enter “2”.
To Next Page
Loading...
