Chapter 4 Cutting Data with Register Marks
104
4.2 Creating Register Marks
Printing image data with "register marks" can increase cutting accuracy and quality. There are some
limitations to register marks. Read the following thoroughly before creating register marks.
• Trimming register marks cannot be used with the machine.
Register Marks
The following three types of register marks can be used with this machine:
Type 1 Type 2 Zero margin register mark
• Use mark 4 (TP4) to perform trapezoidal corrections. Mark 4 can be skipped, but doing so will
reduce cutting accuracy.
Trapezoidal correction: Corrects the difference between the right and left feed amount of the
media.
l
How cutting accuracy varies by speed
Accuracy Speed Register Mark Layout Detection Type
All register marks are detected.Register marks are arranged at the four corners of
each item of image data.
Register marks are arranged at the four corners of
the image data as a whole and at positions
between them.
All register marks are detected (4 marks).
Only the origin register mark is detected (1 mark).
No register marks No register marks
Higher
Lower
Slower
Faster
To Next Page
Loading...
