MIMAKI CJV200-160 - Plotting Areas Around Register Marks

Chapter 4 Cutting Data with Register Marks
108
(Mark shape) Type 1 (Mark shape) Type 2
[Rear]
[Front]
70 mm or more
110 (or 210) mm
110 mm or more
70 to 3,000 mm
: Cut area
: No-plotting area
: Media
15 mm or more 15 mm or more
[Rear]
[Front]
70 mm or more
110 (or 210) mm
+ (Register mark length (B)/2)
or more
110 mm
+ (Register mark length (B)/2)
or more
Within 3,000 mm
: Cut area
: No-plotting area
: Media
15 mm or more 15 mm or more
70 mm or more
• For more information, refer to the ID Cut Guide. https://mimaki.com/download/software.html
No-Plotting Areas Around Register Marks
Do not plot data around register marks. The mark origins may be identified incorrectly, or the machine may
fail to detect the register marks.
(Mark shape) Type 1 (Mark shape) Type 2
〃
〃
〃
〃
(A)
(B)
(B)
: No-plotting area
: Plotting area
〃〃
〃
〃
(A)
(B)
(B)
: No-plotting area
: Plotting area
l
Mark Origin Mis-detection Example
• If register marks are plotted in the no-plotting area as shown in the figure below, the line may be
incorrectly identified as a register mark.
Misidentified
Mark Org
: No-plotting area
: Plotting area