MIMAKI CJV200-160 - Page 118

Chapter 5 Setup
118
Item
Setting
*1
Details
Printing Check ON/OFF Performs nozzle clogging detection before printing starts.
Check Interval - Sets the nozzle clogging detection timing.
Length 0.1 to 30.0 to
100.0 m
Performs nozzle clogging detection after the length set is reached
and before the next print starts.
File 1 to 30 to
1,000 files
Performs nozzle clogging detection after the preset number of files
has been printed and before the next print starts.
Continuation
Print
Stop/
Continuous
Select whether to stop or continue printing if "Nozzle clogging" is
detected.
Action Off/1 to 10 to
100
Performs nozzle recovery (cleaning followed by nozzle checking) if
"nozzle clogging" is detected.
Cleaning Soft/Normal/
Hard
Sets the cleaning type.
Retry Count 0 to 3 times Performs nozzle recovery (cleaning followed by nozzle checking)
for the specified number of times.
Auto Nozzle
Recovery
2
ON/OFF Performs nozzle recovery automatically if "nozzle clogging" is
detected. See below if you wish to perform nozzle recovery
manually.
"Registering Nozzle Recovery Manually"(P. 120)
Judgment
Condition
2
OFF / 1 to 32
nozzles
Set the number of nozzles to be detected as clogged before
"nozzle clogging" is detected. Up to 16 nozzles per row can be set.
The next print will not start if "nozzle clogging" is detected during
continuous printing.
Auto Maint. - Sets various maintenance actions to be performed automatically.
Set the interval between individual maintenance actions.
• If the warning message "Replace Wasteinktank" appears, the
automatic maintenance function is disabled. "Waste Ink
Tank Replacement"(P. 158)
Refresh 0.5/1.0 h Sets the refresh interval (when a small amount of ink is ejected
from the print head nozzles).
Cleaning Interval 1 to 48 h Sets print head cleaning intervals. This will help prevent nozzle
clogging.
Type Normal/Soft/
Hard
Sets the cleaning type for head cleaning.
Print Maint. - Sets the maintenance to be performed automatically midway
during printing.
Auto Cleaning - Sets the conditions to perform head cleaning after the preset
number of files are printed.
Setup File/Length/
Time/OFF
Sets the conditions to perform head cleaning.
Interval - Sets head cleaning intervals.
(File) 1 to 1,000 Cleaning starts when the set number of files is exceeded.
(Length) 0.1 to 100.0
m
Cleaning starts after the length set is reached and before the next
print starts.
(Time) 10 to 240 min Cleaning starts after the print time set is reached and before the
next print starts.