MIMAKI CJV200-160 - Registering Nozzle Recovery Manually

Chapter 5 Setup
120
Registering Nozzle Recovery Manually
Allows other nozzles to be used for printing if maintenance actions like nozzle washing fail to resolve ejection
failures (e.g., nozzle clogging or deflection).
• Nozzle recovery can be specified for up to 20 nozzles per row. The time taken for printing
remains unchanged even when nozzle recovery is set.
• Load media at least 500 mm wide. You cannot print the entire pattern if media less than 500
mm wide is used.
1
Position the media.
2
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
3
Select [Nozzle Recovery] > [Print], then press the [ENTER] key.
• Print a nozzle recovery pattern.
• The Select Entry Nozzle screen appears once printing is complete.
100 0102030405060708090
H1-D K
H1-C Y
H1-B C
H1-A M
1
101
201
301
401
510 0
No.203
H1-A M
Nozzle row number
Head number
Approx. 300 mm
Approx. 330 mm
4
Select the "head number and nozzle row" for nozzle recovery, then press the [ENTER] key.
SELECT ENTRY NOZZLE
Head1-A
>
> Head1-B
>
Head1-C
>
Head1-D
>><<
>
Head1-E
Head number
Nozzle row number
5
Enter the "nozzle number" for nozzle recovery, then press the [ENTER] key.
• Select the entry number before entering the nozzle number.
• Nozzle recovery is set.
Head2-D
No.1
No.2
16
128
No.3
184
No.4
OFF
No.5
OFF
>><<
Entry number 1 to 20
Nozzle number