Chapter 5 Setup
121
6
Press the [ENTER] key once entry is complete.
• Select [Maintenance] > [Nozzle Recovery] > [Test Print], then select "ON" to perform
nozzle recovery and test printing. "Test Printing"(P. 71)
Nozzle Check (Option)
This is used to check for nozzle clogging before printing starts. Sets whether to perform maintenance
functions automatically if nozzle clogging is detected.
If ≥ the set value
[Printing Check]
ON
The nozzles are not checked.
OFF
Performs nozzle recovery automatically.
Nozzle check (nozzle clogging detection)
Continue Printing
If less than the set value
[Judgment Condition] setting for nozzle clogging
detection
[Nozzle Recovery] (cleaning followed by nozzle
checking)
* Repeated by [Retry Count] cycles.
[Judgment Condition] setting for nozzle clogging
detection
Stop Printing
If ≥ the set value
[Auto Nozzle Recovery]
ON
OFF
If less than the set value
5
To Next Page
Loading...
