MIMAKI CJV200-160 - Function Setting Menu

Chapter 5 Setup
122
5.3 Function Setting Menu
This is used to set various operations to ensure optimal machine performance.
l
Menu List
Item
Setting
*1
Details
Logical Seek Host/OFF/ON Sets the range of carriage movement.
• OFF: Machine size area
Unidirectional printing Bi-directional printing
Carriage movement
• ON: Print data area
Unidirectional printing Bi-directional printing
Print data
Carriage movement
Take-up Unit - Sets the take-up unit operation.
Take-up Unit ON/OFF Set to "OFF" if the take-up unit is not used.
Take-up SW Continuous/
Temporary
Sets the function performed by the ON/OFF button on the take-
up unit. Take-up unit
• Continuous: Press the button to start/stop the take-up unit.
• Temporary: The take-up unit operates only while the button
is pressed. The unit stops when the button is released.
Drying Time - Sets the time for ink to dry.
Scan Host/0.0 to
9.9 sec
Sets the stop time of the carriage after each scan.
• The MIMAKI RIP software (RasterLink) indicates this as
"Pause Time per Scan".
Print End Host/0 to 120
min
Sets the stop time after printing. The next data is printed once
the set time has elapsed.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify Print End. If the machine is set to "HOST",
the time will be "0".
Pinch roller
(CJV only)
Sets pinch roller switching.
Skip switching PR ON/OFF Enables or disables automatic pinch roller switching when data
is received. Refer to the following to change the pinch roller
pressure. "Setting the Pressure and Number of Pinch
Rollers to Use"(P. 69)
Power Setting - Sets the times to turn the power on and off automatically.