Chapter 5 Setup
123
Item
Setting
*1
Details
Auto Power-off 5 to 15 to 60
min
Sets the time until the power is automatically turned off.
Auto Power-on - Sets the time to automatically turn on the power.
Setup ON/OFF Sets whether to turn on or off the power.
Time 0:00 to 23:59 Sets the time to turn on the power.
Day Monday to
Sunday
Sets whether to turn on or off the power on each day of the
week.
Nozzle Check ON/OFF Automatically executes the nozzle check function when the
machine is started with auto power-on. Performs nozzle
recovery (cleaning followed by nozzle checking) if "nozzle
clogging" is detected.
Cleaning Soft/Normal/
Hard
Sets the cleaning type.
Retry Count 0 to 3 times Performs nozzle recovery (cleaning followed by nozzle
checking) for the specified number of times.
Use PR Number Query
(CJV only)
ON/OFF Sets whether to display the screen for entering the number of
pinch rollers to be used after media width detection.
• ON: Displays the input screen.
• OFF: The "host" takes priority. Set this to "OFF" when
configuring pinch roller pressure settings on this machine.
Setting the Pressure and Number of Pinch Rollers to Use
WhiteSpace Setting - Sets the offset value from the media left and right standard
margins (15 mm).
• The left and right margins should be set to at least -5 mm
when using the media holder. This eliminates the risk of
printing on top of the media holder.
• The Mimaki RIP software (RasterLink) does not allow the
user to specify margins. If the machine is set to "Host", the
offset value will be "0 mm" for the left and right margins.
Margin -
Margin/Left Host/-10 to 85
mm
Margin/Right
Space Btwn PP. None/10 to
500 mm
The space between prints can be eliminated for continuous
printing.
• Reducing the space length may cause media sagging,
resulting in discrepancies in the distance the media is fed.
• The actual space may be wider than set, depending on the
size of image data and number of passes in the feed
direction.
Space Feed Mode Intermittent/
Continuous
Alters the feed method for blank space included in the image
data.
• Intermittent: Uses intermittent feeding based on the timing of
a fraction of the pass.
• Continuous: Feeds forward by skipping blank parts.
View Feed ON/OFF Sets whether or not to feed the media forward to view the print
results—for example, during test printing.
Feeding Before Cut ON/OFF Sets whether to feed media before cutting the media.
Auto Remote ON/OFF Sets whether to automatically switch to REMOTE mode and
start printing if data is received locally.
600 cc cartridge
*2
- This is displayed when using 600 ml ink cartridges in the ink
supply unit.
5
To Next Page
Loading...
