Chapter 5 Setup
126
Correct the ink cartridge weight
When the remaining ink level in the 600 ml ink cartridge falls to the corresponding value, [Ink Level Low], [Ink
Near End], [Ink Level End], or [Ink End] is displayed, accordingly. The 600 ml ink cartridge weight should be
corrected, as the displayed weight may differ from the actual weight.
• Note that repeatedly registering a value different from the actual weight will render the ink IC
chip unusable.
• Continuous printing is not possible when a warning is displayed.
• If "Replace Inkpack" appears, replace the ink pack with a new one.
1
A warning appears on the display.
2
Remove the 600 ml ink cartridge from the ink slot indicated, and weigh it.
• Weigh the ink cartridge with the ink pack inside it.
3
Install the 600 ml ink cartridge in the ink supply unit.
• The cartridge weight screen appears.
4
Enter the measured weight of the 600 ml ink cartridge, then press the [ENTER] key.
• The remaining ink level inside the ink pack is calculated and stored in the ink IC chip.
• The 600 ml ink cartridge weight can also be registered as follows:
(1) On the LOCAL mode screen, select [MENU] > [Machine Setup], then press the [ENTER] key.
• The Machine Setup menu is displayed.
(2) Select [600 cc cartridge] > [Cartridge Weight], then press the [ENTER] key.
(3) Select the corresponding ink slot, then press the [ENTER] key.
• The selected slot is highlighted.
(4) Enter the measured weight of the 600 ml ink cartridge, then press the [ENTER] key.
• If "ERROR 614 Preservation Failure" appears, check the following:
(1) Check to confirm that the 600 ml ink cartridge has been pushed in fully.
(2) Check to confirm the ink IC chip has been inserted correctly.
To Next Page
Loading...
