Chapter 5 Setup
133
• With the following data, only one sheet can be cut, regardless of the number of copies specified.
(1) Data received from MIMAKI RIP software (RasterLink).
(2) Data for which "Sheet Feed Origin Renewal" has been selected in the MIMAKI cutting
software (FineCut).
• When sending the cut data from the PC, wait for at least 5 seconds before sending the next
data. If the next data is sent within 5 seconds, both pieces of data may be copied.
Preventing Uncut Media
Overlapping the start and end points can prevent the media from being left uncut. Configure this setting for
very flexible media.
If the setting is too large, the print may also be cut. Alter the setting while checking using a test cut. "Test
Cutting"(P. 97)
l
Over Cut
The machine cuts the media in front of the cutting start point by the set value. The media is overcut by the
set value at the end point.
Over Cut: OFF Over Cut: 0.1 to 1.0 mm
l
Corner Cut
When the Over Cut setting value is entered, Corner Cut is displayed. The machine performs over cutting at
corners other than the start and end point.
Corner Cut: OFF Corner Cut: ON
5
To Next Page
Loading...
