MIMAKI CJV200-160 - Ink Discharge Channel Cleaning

Chapter 6 Maintenance
144
5
Clean the DAS sensor.
• Wipe clean using cotton swabs or a soft cloth.
• For heavy soiling, wipe using a soft cloth soaked in diluted neutral detergent and
thoroughly wrung out.
6
Once cleaning is complete, press the [ENTER] key.
7
Close the maintenance cover (left side), then attach the maintenance cover (upper left side).
Ink Discharge Channel Cleaning
Clean the ink discharge channel regularly to prevent clogging of the ink discharge channel below the cap.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station Maint.] > [Pump tube cleaning], then press the [ENTER] key.
3
Open the maintenance cover (right side).
4
Fill the cap with maintenance liquid.
• Use a syringe to draw up some maintenance liquid and fill until it almost overflows from
the cap.
5
Close the maintenance cover (right side), then press the [ENTER] key.
• Pump tube (ink discharge channel below the cap) washing starts.