MIMAKI CJV200-160 - Page 171

Chapter 7 Troubleshooting
171
• Note that the input units vary depending on whether or not register marks are used.
Without register marks
1
Click [OK] to print a correction pattern.
2
On the REMOTE mode screen, select [Adjust].
3
Select [PC Origin Offset], then press the [ENTER] key.
• A correction pattern is cut. Detach the cut part of the pattern and check the adjustment values.
+-
-+
4
Input the numerical value of the position with the lowest vertical misalignment.
• In the illustration below, enter "-4".
-2 -5-4-3 -6
Enlarged X
5
Input the numerical value of the position with the lowest horizontal misalignment.
• In the illustration below, enter "2".
4 123 0
Enlarged Y
With register marks
1
Select [Add register mark].
2
Click [OK] to print a correction pattern.
3
On the REMOTE mode screen, select [Adjust].
7