MIMAKI CJV200-160 - Page 174

Chapter 7 Troubleshooting
174
Message Cause Corrective action
Media Undetected • The media width has not
been detected.
• Detect the media width. "Loading
the Media"(P. 54)
Wiper Move Failure • The wiper is not operating
correctly.
• Turn off the main power and wait a
while before turning back on.
Replace Wasteinktank • The waste ink tank count
exceeded the preset
value (90%).
Automatic maintenance is not possible
while the covers are open. Perform the
following steps:
1. Check the waste ink levels in the waste ink
tank. "When "Check Waste Ink Tank"
message appears"(P. 159)
2. Replace the waste ink tank, then reset the
waste ink level. "Replacing the Waste
Ink Tank"(P. 159)
Check Waste Ink tank • The waste ink tank count
exceeded the preset
value (80%).
1. Check the waste ink levels in the waste ink
tank. "When "Check Waste Ink Tank"
message appears"(P. 159)
2. Replace the waste ink tank, then reset the
waste ink level. "Replacing the Waste
Ink Tank"(P. 159)
High ambient temp ** ﾟC • Ambient temperatures are
too high.
• Adjust ambient temperatures to
temperatures within the specified range.
Optimum print quality may not be
possible unless ambient conditions are
within the specified range.
"Installation Precautions"(P. 16)
Low ambient temp ** ﾟC • Ambient temperatures are
too low.
Auto-correction failed • White media is not used.
• The media is dirty.
• The media lifts up.
• There is dirt around the
sensor.
• Load white and clean media.
• Load media so it does not lift up.
• Clean the area around the sensor.
"DAS (automatic correction function) /
Sheet width sensor cleaning"(P. 143)
• If automatic correction fails repeatedly,
correct the position manually. "Feed
Correction"(P. 75) "Correcting the
Drop Position"(P. 77)
*1 NCU is optional.