Chapter 7 Troubleshooting
181
Error
number
Message Cause Corrective action
702 Thermistor Connect • A problem was detected
with the thermistor
connection.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
703 Heater Brk • A problem was detected
with the heater
temperature.
710 Heater Temp Error • A problem was detected
with the heater
temperature.
• This error will be automatically
resolved. If the error is not resolved,
turn off the main power and wait a
while before turning back on.
801 (C) OPCODE • A problem was detected
with the main PCB.
• Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
802 (C) SWI
803 (C)PFTCHABRT
804 (C)DATAABRT
806 FW/SIO bit • A communication error
was detected between the
boards.
808 FW/STP-MTR** • A problem was detected
with the main PCB.
80f FW/SIO Vch • A communication error
was detected between the
boards.
811 FW/SIO read • A communication error
was detected between the
boards.
81b FW/STACK OV • A problem was detected
with the main PCB.
828 PRG ERR L*****
901 Operation Error • The function is disabled
due to an error.
• Check the error details.
– Media Undetected
– Ink error
– Waste ink tank, etc.
902 Data Remain • Print (RIP) data was
received.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
90f Print Area Short • The media is too small for
the print.
• Replace with wider or longer media.
• If the printable area is reduced due
to a shift in the origin, move the
origin to increase the size of the
printable area.
b49 PCB VHVFET[1] • A problem was detected
with the PCB power
supply.
Turn off the main power and wait a
while before turning back on.
"Turning Off the Power"(P. 31)
C10 Command • Received a code other
than a COMMAND code.
1. Clear the data and resend.
2. Check the USB/Ether cable connection.
"Connecting a PC to the
Product"(P. 33)
7
To Next Page
Loading...
