Chapter 1 Before Use
31
2
Hold down the [END/POWER] key to turn on power. (Press the key until the red LED on the
upper right side illuminates.)
• The firmware version appears on the display, and the initial operation is executed. The machine
will then enter the Media Select mode, and is ready for use.
3
Turn on the power for the connected PC.
• Close the maintenance cover. Leaving any of the covers open will disable the automatic
maintenance function (including nozzle clogging prevention function and waste ink draining
channel cleaning function). This will increase the risk of failure or ejection failures (e.g., nozzle
clogging or deflection).
Turning Off the Power
• Check the following when turning off power:
(1) The front cover is closed.
• Leaving any of the covers open will disable the automatic maintenance function (including
nozzle clogging prevention function and waste ink draining channel cleaning function).
(2) The carriage has returned to the capping station.
• If not, the print head nozzle may dry out, resulting in ejection failures (such as nozzle
clogging or deflection).
(3) The cutter unit must be connected to the carriage.
• If a cutter unit is equipped, the buzzer sounds when the cutter unit is away from the
carriage side. When the cutter unit is connected to the carriage side, the buzzer stops
sounding and the machine turns off.
(4) Data is not being received
(5) No errors have occurred.
• Problems Causing Messages to Appear
1
Turn off the power to the PC connected.
2
Hold down the [END/ POWER] key.
• A power off confirmation screen appears. Press the [ENTER] key to turn the power off.
1
To Next Page
Loading...
