MIMAKI CJV200-160 - Setting Leaf Media

Chapter 2 Printing
64
Setting Leaf Media
• This setup applies to CJV200 models.
• Move the take-up unit out of the way to the left and right when it is not in use. Print quality may
be affected if the front edge of the media hits the take-up unit.
1
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
• The Media Setting menu is displayed.
2
Select [Media Information] > [Media Operation Form] > [Leaf], then press the [ENTER] key.
• The media bottom end will not be detected if Leaf is not selected.
3
On the LOCAL mode screen, select [MENU] > [Media Setting], then press the [ENTER] key.
4
Raise the clamp lever.
5
Insert the media.
• Insert into the gap between the pinch rollers and the grit rollers.
• Inserting the media at an angle allows smooth insertion without catching or sticking.