Chapter 2 Printing
65
6
Adjust the position of the right media edge.
• Set the media straight so that the media does not lie beyond the slit line on the platen.
First three grit rollers from the right end on the front of the machine
• The areas extending 5 mm from both sides of the media are margins.
7
Adjust the position of the front media edge.
• Set the media so that about 40 mm of it lies on the after cover. If not, the media width may not be
detected.
8
Lower the clamp lever to confirm that the spacing from the pinch roller is uniform.
• Hold the media with the pinch roller and grit rollers.
• "Adjust the Pinch Roller Positions."(P. 50)
• If the spacing is not uniform, repeat all steps from the start.
9
Secure the media in the media holder.
Media holder
CJV200 shown here
• Do not use the media holder when printing on thicker media.
• Do not use the media holder when cutting media.
• Use the media holder when detecting media.
2
To Next Page
Loading...
