Chapter 2 Printing
74
2.9 Auto Correction
The auto-correction function (DAS: Dot Adjustment System) detects a correction pattern with the sensor and
automatically corrects the drop position.
1
On the LOCAL mode screen, select [ADJUST].
0.0mm
LOCALADJUST
LOCAL
ADJUST
2
Select [Auto-correction], then press the [ENTER] key.
3
Select a setting item, then press the [ENTER] key.
• The following three items can be configured:
[All]: Automatically performs feed and dot position correction.
[Feed Comp.]: Automatically performs feed correction.
[Drop.PosCorrect]: Automatically performs dot position correction.
• Dot position correction can also be performed for each printing condition. In this case, select
[Media Setting] > [Auto-correction] > [Drop.PosCorrect] > [Printing conditions], then press the
[ENTER] key.
• Check to confirm that the media does not lift up.
• Load white and clean media.
• Media such as synthetic paper, tarpaulin, or cloth media may not be detected.
• Do not send RIP data from the PC during pattern printing.
• If automatic correction is unsuccessful, correct the position manually. [MENU] > [Media Setting]
> [Feed Comp.] or [Drop.PosCorrect] "Feed Correction"(P. 75) "Correcting the Drop
Position"(P. 77)
To Next Page
Loading...
