Chapter 3 Cutting
88
3.2 Installing Cutting Tools
This machine can be used with the following tools:
• Cutter (for cutting media)
Used to cut the printed image on media or to cut characters with the cutting sheet. "Using the
Cutter"(P. 88)
• Pen (ballpoint pen)
Used to adjust register marks This machine can be used with a ballpoint pen or cartridge refill. "Using
a Pen"(P. 92)
Using the Cutter
Use the provided cutter holder
Be careful to keep the cutter from falling into a gap in this machine. We recommend replacing the cutter on
the media so you can easily pick up the cutter blade if it falls.
• Avoid touching the cutter blade. Failure to do so may result in injury.
• Do not shake the cutter holder. The cutter blade may come out.
1
Turn the adjusting knob on the cutter holder in the direction of the arrow to bring out the
cutting blade.
• To replace the cutter blade, turn the adjusting knob on the cutter holder in the direction of
the arrow to remove it and replace it.
To Next Page
Loading...
