MIMAKI CJV200-160 - Installing the Cutter Holder

Chapter 3 Cutting
90
Installing the Cutter Holder
1
On the LOCAL mode screen, select [MENU] > [Cutting], then press the [ENTER] key.
• The Cutting menu is displayed.
2
Select [Tool Change], then press the [ENTER] key.
• The cutter unit moves to the maintenance space.
• The cutter unit can be moved manually. Move the carriage slowly to a position allowing
easy access while working.
3
Turn the knob screw and loosen the holder presser.
Holder presser
Knob screws
4
Insert the cutter holder into the tool holder.
• Push the brim of the cutter holder against the holder presser.
Brim
5
Secure the cutter holder.
• Turn the knob screw to secure the holder presser. Failure to secure firmly may result in lower
quality.
Knob screws
6
After installing the cutter holder, press the [ENTER] key to finish the process.