6-16
When not using for a long term (firmware Ver. 2.30 or later)
When the operation of the machine is to be suspended for 24 hours or more, use the NOZZLE PROTECT
function to protect the nozzle surface.
This function is available for the firmware Ver. 2.30 or later.
Execute the NOZZLE PROTECT function
1
Press the key in LOCAL to select the
printing mode.
2
Select [ST. MAINTENANCE] of the maintenance menu.
(1) Press the key.
(2) Press to select [MAINTENANCE] and press the key.
3
Press the key.
4
Press to select [NOZZLE PROTECT].
5
Press the key.
• The carriage moves onto the platen.
6
Press the key.
• The NOZZLE PROTECT function is executed.
• When NOZZLE PROTECT function is finished, the power is automatically turned off and the machine
enters a nozzle protection status.
• In the nozzle protection status, it executes NOZZLE PROTECT regularly. Keep the main power switch on.
Also, check that it has enough maintenance washing liquid.
Check the items
on the right
beforehand.
Has maintenance washing liquid been filled?
• If maintenance washing liquid has not been filled, fill it by referring to P.6-9 “Filling the
Pump Tube with Cleaning Solution for Maintenance”.
Hasn’t a warning occurred in the maintenance washing liquid cartridge?
• If the warning message of [Wash Liquid Cart. NONE], [Wash Liquid END] or [WRONG
WASH CART.] is displayed, set a proper maintenance washing liquid cartridge to solve
the warning.
• When the following messages are displayed, check the waste ink tank and perform the operations
described on P.6-39 "If a Waste Ink Tank Confirmation Message Appears" as necessary.
• In the nozzle protection status, maintenance in the sleep status does not work.
• If the power is turned on after executing NOZZLE PROTECT function,
this machine automatically performs (1) and (2) described below and
then displays a message shown in the right. After checking the
message, perform test drawing to check the nozzle status.
(1) Discharges washing liquid filled in the cap.
(2) Executes normal cleaning of the head cleaning automatically.
Con f i rm a was t e tan k
Con t i nue< >Exchange
Con f i rm a was t e tan k
Exchange :
e nt
<LOCAL . 1> [ #01 ]
WIDTH:****mm
ST . MA I NTENANCE
CARR I AGE OUT < e n t >
ST . MA I NTENANCE
NOZZLE PROTECT < e n t >
NOZZLE PROTECT
EXECUTE : en t
<LOCAL . 1> [ #01 ]
!Do TEST DRAW
To Next Page
Loading...
