6-34
Setting the Interval between Each PUMP Tube Washing Operation in the Standby Mode
The PUMP tube is washed regularly to prevent nozzle clogging caused by ink coagulation in the tube.
1
Press the key in LOCAL to select the
printing mode.
2
Select [ROUTINE SETUP] of the maintenance menu.
(1)Press the key.
(2)Press to select [MAINTENANCE] and press the key.
(3)Press to select [ROUTINE SETUP].
(4)Press the key.
3
Press to select [PUMP TUBE WASH].
4
Press the key.
5
Press to set the interval between each PUMP
tube washing operation.
• Set value: OFF or 1 to 168 hours
6
Press the key.
7
Press the key several times to end the setting.
• This function can be performed only when the states shown by the screens below are maintained.
• When the machine has not been filled with cleaning solution, the
screen on the right appears in Step 5. Fill the machine with
cleaning solution ( P.6-10) and perform the operations in Step 1
and later.
• If the cleaning solution is not set, it does not work.* Set the
cleaning solution.
*
For [!Wash Liquid END], it works to use up the cleaning solution, however, replace early.
<LOCAL . 1> [ #01 ] *REMOTE. 1* [ #01 ]
0.00m
LOCAL REMOTE
<LOCAL . 1> [ #01 ]
WIDTH:****mm
ROUT I NE SETUP
PUMP TUBE WASH < e n t >
ROUT I NE SETUP
WA S H I N T E R V A L =
1 h
ROUT I NE SETUP
WA S H I N T E R V A L =
4 h
ROUT I NE SETUP
PUMP TUBE WASH < e n t >
*WashL i qu i d UN-FI LL*
<LOCAL .C >!WSH [#01]
CUT 1 ( 3 0 / 6 0 / 0 . 3 0 )
<LOCAL . 1> [ #01 ]
!WashL i qu i dCar t .NONE
or
To Next Page
Loading...
