3-43
Machine Settings
3
Extended Functions – Printer –
When the eco case weight is changed
When the case weight is changed by replacing the eco case, register the weight of the eco case in the following
procedures.
1
Press the key in LOCAL to select the
printing mode.
2
Press the key.
3
Select [MACHINE SETUP] by pressing the
keys.
4
Press the key.
5
Select [600cc Cartridge] by pressing the
keys.
• When the 600 cc cartridge is not set,
“ 600 cc Cartridge” will not be displayed.
• It is recommended to measure the weight of the eco case in
advance and then perform the procedure from the Step 5.
6
Press the key.
7
Select [Slot] by pressing the keys.
• The selected slot is highlighted.
8
Press the key.
• The weight input screen is displayed.
9
Pressing the keys input the
weight of the eco case.
• Press the keys to move to another digit.
• Press the keys to input the weight.
10
Press the key.
• The slot selection screen is displayed again.
• When you want to register the weight of another slot continuously,
repeat the Step 6 to select a slot.
11
Press the key several times to end the setting.
<LOCAL . 1> [ #01 ]
WIDTH:****mm
FUNCT I ON
SETUP <ENT>
FUNCT I ON
MACH I N E SE T U P < EN T >
MACH I N E SE T U P
DEODOR I Z E FAN < e n t >
MACH I N E SE T U P
600cc Ca r t r i dge<en t >
CART . S l o t s e l e c t
1 .34. .7.
CART . S l o t s e l e c t
1.3
4 ..7.
CART.Slot ..3.....
case we i ght = 30
0 g
CART.Slot ...4....
case we i ght = 35
5 g
CART . S l o t s e l e c t
1.3
4 ..7.
To Next Page
Loading...
