6-24
Supplying the Machine with Ink Anew
After you have performed [DISCHARGE & WASH], supply the machine with ink anew with the following
operations.
1
Turn on the power of the machine.
• When the power is turned on, the firmware version is displayed
following [BOOT].
2
Check the ink type to fill, and then press
the key.
• To check the state of the cartridge, press the key. ( P.7-5)
3
Check the ink set (the color) to fill, and then press the key.
• You cannot change the current ink set to another by yourself.
• If you want to change the ink set, contact our service office.
4
Press the key.
BOOT
CJV30BS- 60 V* . * *
Please Wai t
INK TYPE
BS2 So l
BS2 I NK SET
4 - Co l o r (MMCCYYKK )
Set :BS2-4color Ink
--------
To Next Page
Loading...
