© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2 P.4
4.2 Assembling the Stands and the Device
R.1.0
1
2
3
4
5
6
7
4. Remove the guide caps.
5. Put the roll holders on the roll guide, and tighten the roll
holder fixing screws.
6. Put the take-up device units on the roll guide, and tighten the
take-up device unit fixing screws.
7. Fit the guide caps on both sides of the roll holder assy and the
take-up device assy, then temporarily tighten them with the 4
hexagon socket head screws (SSWP4x4(R)) (such that the
screw touches the roll guide).
8. Provisionally fix the roll holder assy and take-up device assy to
the roll guide BKT, using the four screws (M5x15 screws).
Roll holder
fixing screw
Roll holder
Roll guide
Roll holder
Roll guide
Take-up device unit fix-
ing screw
Take-up device unit
fixing screw
Take-up device unit
Take-up device unit
Guide
cap
Guide
cap
Temporary tightening
Temporary tightening
Temporary tightening
Temporary tightening
Use the provided hexagonal wrench (size 2).
INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
To Next Page
Loading...
