MIMAKI CJV300-130 - Installation and Environmental Cautions

© 2014 MIMAKI ENGINEERING CO.,LTD. 4.2 P.5
4.2 Assembling the Stands and the Device
R.1.0
1
2
3
4
5
6
7
9. Tighten the 4 screws (M5x14, 4pcs) that were temporarily
tightened on the step 8.
While pressing the roll holder assy and the take-up device
assy towards the leg stay, affix the roll guide BKT.
10. Tighten the 4 hexagon socket head screws (SSWP4x4(R)) that
were temporarily tightened on the step 7. (Tighten the screw
90°angle once it hits the roll guide.)
11. Lock the four stoppers of the stand.
P
r
e
s
s
i
n
g
d
i
r
e
c
t
i
o
n
P
r
e
s
s
i
n
g
d
i
r
e
c
t
i
o
n
Pressing
Pressing
Tightening
Tightening
 Pay attention to the guide caps’ orientation.
 Make the guide cap ridge press against the roll
guide BKT. (Refer to the left figure)
Attach facing up the side having a screw hole.
Tightening
Tightening
INSTALLATION GUIDE > Printer Assembly > Assembling the Stands and the Device
Model
CJV300
Issue
2014.09.01
Revised F/W ver. 1.30 Remark
1.0
Rev.