MIMAKI CJV300-130 - Powering the Machine On and Off

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.1 P.3
5.1 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
5. Loosen the four screws in the left figure.
6. Pull out the CPS angle spacer 1.
7. Insert the CPS angle spacer 1 pulled out under the CA right
base.
8. Pull out the CPL angle spacer 2.
9. Insert the CPL angle spacer 2 pulled out under the CA left
base.
10. Tighten the four screws loosened in the Step 6.
CPL angle spacer 2
 Use the accessory driver (150mm) to loosen the
CPL angle spacer 2.
CPS angle spacer 1
CA right base
CA left base
CPL angle spacer 2
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
Rev.