© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.2R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
7.1 Performing the Initial Ink Fill
Working procedure 1 (Ink set selection)
1. Dip the clean stick into the washing solution, and moisten the
edges of cap.
The machine can not recognize if the filling fluid cartridge has been set or removed. Be sure to check
the condition before performing each operation.
Set a cartridge of the filling fluid or the ink according to the displayed.
Set the cartridges in the order correctly.
Be sure to use a new cartridge or one with at least half the ink remaining.
Before ink charging, make sure that the fitting is firmly connected.
Also make sure that the fitting is not contacting the tube clamp.
To Next Page
Loading...
