MIMAKI CJV300-130 - Page 41

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.3
7.1 Performing the Initial Ink Fill
R.1.0
1
2
3
4
5
6
7
2. Turn the power to the device on.
When the power is turned on, the firmware version is displayed.
3. Select the ink type.
AQUA: Aqueous ink (sb53, etc.)
SOLVENT: Solvent ink (SS21, etc.)
4. Press the [ENTER] key.
5. Select the ink set.
6. Press the [ENTER] key.
LOCAL
Boot(logo)
MENU
TEST PRINT/
CLEANING
REMOTE
LOCAL
version
MENU
TEST PRINT/
CLEANING
REMOTE
LOCAL
MENU
TEST PRINT/
CLEANING
REMOTE
 Ensure the front cover is closed.
Select INK SET
○ AQUA
○ SOLVENT
MENU
TEST PRINT/
CLEANING
REMOTE
Select INK SET
○ 4 color
○ 6+W color
○ 6+WS color
○ 8color
MENU
TEST PRINT/
CLEANING
REMOTE
 Ink set can be select at installation or at performing head cleaning (the user cannot replace it).
 When you change the ink set, change the joint of the ink path. (5.1 (p.2))
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
CJV300
Issue
2014.09.01
Revised F/W ver. 1.30 Remark
1.0
Rev.