© 2014 MIMAKI ENGINEERING CO.,LTD. 7.2 P.9R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Outputting Plots > Performing a Test Print
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
7.2 Performing a Test Print
Outline
Perform a test print to check that there are no ejection problems (smears or gaps) such as blocked nozzles.
Work procedures
1. Press the [FUNC2] key in local mode.
2. Press the [] key then the [ENTER] key.
The test print begins.
When the printing finishes, the printer returns to local.
If you are using loose-leaf media, load media with a size larger than A4 size portrait.
If you are using roll media, wind back the roll media by hand to remove any slack before beginning
printing. Otherwise, this could cause poor printing quality.
Items to check before the test print
Is media loaded (Operation Manual)
Is the origin point set
Is the head cap adjusted (Operation Manual)
LOCAL
1590mm
Heater///
Ink///
MENU
TEST PRINT/
CLEANING
REMOTE
Press [][] to change the orientation of the test pattern.
Refer to the Operation Manual for details on the test print direction.
TEST PRINT >
CLEANING >
STATION MAINTENANCE >
TEST PRINT
SCAN DIR. >
FEED DIR. >
TEST PRINT
PRINTING
Prease Wait…
To Next Page
Loading...
