MIMAKI CJV300-130 - Test Cutting Procedures; Cutting Data Setup

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.5 P.15R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Outputting Plots > Dot Position Adjustment (User menu)
Model
CJV300
Issue
2014.09.01
Revised F/W ver. 1.30 Remark
1.0
Rev.
7.5 Dot Position Adjustment (User menu)
 Work procedures
1. Load the media and set the print origin.
2. Press the [MENU] key in local mode.
3. Select [SETUP] and press the [] key.
4. Select [DROP.POScorrect] and press the [] key.
5. Press the [ENTER] key.
6. Press the [ENTER] key to start the pattern print.
Multiple test patterns are printed.
(The are called patterns 1, 2, 3, etc. in printing order)
7. Press [][] to correct the dot position of pattern 1.
• Correction value:
- 40 to 40
• Check the test pattern to ensure the correction value is the
position where the outgoing direction and return direction
form a single straight line.
• If the correction value is not in the range of
- 40 to 40, adjust
the head height and then repeat the procedure from Step 2.
8. Press the [ENTER] key.
SETUP
FEED COMP. >
DROP.POScorrect >
HEATER >
LOGICAL SEEK HOST
< page page >
LOCAL
1590mm
Heater///
Ink///
MENU
TEST PRINT/
CLEANING
REMOTE
MENU
SETUP >
MAINTENANCE >
MACHINE SETUP >
INFORMATION >
DROP.POScorrect
PATTERN1 0
PATTERN2 0
PATTERN3 0
PATTERN4 0
DROP.POScorrect
PRINT START
DROP.POScorrect
PRINTING
Please Waint…
:-40.0 〜 40.0