13
(4)
Replacing the pen line rubber or pen line sponge.
There are two types of pen line, one is rubber type and the other is sponge type.
Use the pen line rubber when writing with a pen or cutting a sheet.
Use the pen line sponge when cutting on the dotted line (half cut).
If the pen line rubber (PN: SPC - 0770 or SPC - 0771) or pen line sponge gets worn, replace it (PN: SPC -
0775 or SPC - 0776).
1
Remove a pen line rubber or pen line sponge with tweezers.
• If double-sided tape glue remains in the groove of this
machine, wipe off the glue with alcohol.
2
Attach the attached double-sided tape to the groove of this machine.
3
Put a new pen line rubber or pen line sponge on double-sided tape.
• Put a new pen line rubber or new pen line sponge flattened
on the two-sided tape.
To Next Page
Loading...
