Safety Precautions
ix
Precautions in Use
Hazardous Moving Parts
• Keep Fingers and Other Body Parts Away
• If a foreign object such as a small piece of metal or
a liquid such as water gets inside the machine, turn
off the machine and unplug the power cord
immediately, then consult your service
representative. Continuing to use the machine
without proper maintenance or repair may result in
fire or electric shocks.
• Do not use a flammable spray or solvent inside or
around the machine. Doing so may result in fire or
electric shocks.
• Do not place a vase, flower pot, water glass,
container with liquid such as water or chemicals
inside, or small metallic object near or on top of this
machine. Liquid or foreign object may get inside the
machine, leading to fire or electric shocks.
WARNING
CAUTION
Handling of the power cable
• Connect to a socket-outlet with determinate
polarity.
• For Inlet 1 and 2, be sure to supply power from
the outlet of the same voltage.
• for PLUGGABLE EQUIPMENT, the socket-
outlet shall be installed near the equipment
and shall be easily accessible.
• Unplug the cord from the wall outlet and
remove dust from the power plug periodically,
at least once a year. Failure to do so may
result in fire or electric shocks.
• Do not use the machine unless it is connected
to a power supply that satisfies the displayed
voltage condition.
• Check the voltage of the wall outlet and the
capacity of the circuit breaker before you plug
the power cords. Plug each power cord to
different outlet that has independent circuit
breaker. If you plug more than one power cord
to wall outlets that share the same circuit
breaker, the power may be cut off by the
breaker.
Power supply
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
Heater
• Do not spill liquid on the Media Transfer
Surface as this may cause failure of the heater
or firing.
• Do not touch Media Transfer Surface heaters
with bare hand while it is hot; otherwise, you
can get burned.
Note on maintenance
• When cleaning the ink-station or the heads,
make sure to wear the attached goggles and
gloves.
• The gloves supplied with the machine are
disposable. When all the gloves are
expended, purchase an equivalent product on
the market.
• Keep ink away from an open flame. Also keep
the room well ventilated when you use or
handle ink.
Be careful with the movable parts
• Do not touch the rolling grit roller; otherwise,
you may hurt your fingers or tear off your
finger nails.
• Keep your head and hands away from any
moving parts during cutting (plotting)
operation; otherwise, you may get your hair
caught in the machine or get injuries.
• Wear proper clothes. (Do not wear loose-fit
clothes or accessories). Bind a long hair.
To Next Page
Loading...
