MIMAKI CJV300-130 - Head Nozzle and Ink Discharge Passage Washing

5-7
5
2
6
Set the wiper at the original position.
• Insert the wiper by holding the protrusions at its
both ends.
7
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
8
Press the key after the cleaning.
9
Close the front cover then press the
key.
• After its initial operation, the machine returns to
step1.
Washing the Head Nozzle
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key.
• “STATION” will be selected.
3
Press , and then press the
key.
• “NOZZLE WASH” will be selected and the
carriage will move onto the platen.
4
Clean the wiper and the bracket, and then
press the key.
(1) Open the right maintenance cover then pull
out it by holding projections at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance. ( )
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Clean the cap rubber , and then press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
Projection
Cap rubber
Carriage
Projection