5-12
5
Register the Nozzle number that needs
NOZZLE RECOVERY and then press
key.
(1) Select the registration number from 1 to 10
by pressing [][] key and press the
[ENTER] key.
(2) Register the nozzle number that needs
recovery by pressing [][] key and press
the [ENTER] key.
6
Press the key several times
to end the setting.
Reset the set value
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press , and then press the
key.
• “NOZZLE RECOVERY” will be selected.
3
Press twice, and then press the
key.
• “RESET” will be selected.
4
Press and
(PAGE>)
(<<)
to selet theNozzle line that
need reset, and then press the
key.
• A reset confirmation message will be displayed.
5
Press the key.
6
Press the key several times
to end the setting.
• Up to 10 nozzles can be registered per 1 nozzle
line.
• Even if you use this function, time required for
drawing does not change.
• When printing has been done with the lowest path,
nozzle recovery is not reflected.
Moreover, depending on the conditions, there are
cases where only 20 to 120 nozzles are enabled at
both head ends (front and rear). Perform test
printing to confirm.
• When you use white ink, print on the clear film to
check.
Recovery nozzle No. or OFF
Registration number : 1 to 10
Nozzle missing
No.184
Nozzle number
Nozzle missing No.16
Nozzle missing
No.128
Registration
number
Recovery
Nozzle No.
State
1 16 Target for nozzle recovery
2 128 Target for nozzle recovery
3 184 Target for nozzle recovery
4 OFF No registration
5 OFF No registration
Example of nozzle to be recovered
To Next Page
Loading...
