x
Safety Precautions
1
2
2
2
2
2
1
CAUTIONS and NOTES
Caution with cutters
• Do not touch the cutter blade, which is very
sharp.
• Do not shake or swing the cutter holder;
otherwise, the blade may come off.
Handling of ink
• Keep ink away from an open flame. Also keep
the room well ventilated when you use or
handle ink.
• If you get ink in your eyes, immediately wash
your eyes with a lot of clean water for at least
15 minutes. In doing so, also wash eyes to
rinse ink away completely. Then, consult a
doctor as soon as possible.
• If anyone drinks ink by mistake, keep him or
her quiet and see a doctor immediately. Do not
allow him or her to swallow the vomit.
Then contact the emergency number written in
MSDS.
• If you inhale a lot of vapor and feel bad,
immediately move to a location of fresh air
and then keep yourself warm and quiet. Then,
consult a doctor as soon as possible.
• Store ink cartridges in a place that is out of the
reach of children.
• If the ink adheres to your skin, use a large
amount of water and soap or special detergent
for skin to remove the ink.
CAUTION
Warning
Clump lever
• Never raise the lever during printing. Raising the lever will
abort printing.
Protection of media from dust
• Store media in a bag. Wiping off dust accumulated on media
will adversely affect the media due to static electricity.
• When leaving the workshop after the working hours, do not
leave any media on the roll hanger. If any media is left on the
roll hanger, it can get dusty.
Periodic replacement parts
• Some parts of this machine must be replaced with a new
one periodically by service personnel. Be sure to make a
contract with your distributor or dealer for After sale service
to ensure a long life of your machine.
Disposition of this machine
• Consult your sales or service representative for proper
disposal of this machine. Otherwise, commission an
industrial waste disposal company.
Protection of media from dust
• Store media in a bag. Wiping off dust accumulated on media
will adversely affect the media due to static electricity.
• When leaving the workshop after the working hours, do not
leave any media on the roll hanger. If any media is left on the
roll hanger, it can get dusty.
Handling of ink cartridges
• The safety evaluation of this machine assumes that the ink
recommended by this company is used. For safe usage of
this machine, use the ink recommend by this company
• Never refill the ink pack and white ink cartridge with ink.
Refilled ink cartridge can cause a trouble. Remember that
MIMAKI assumes no responsibility for any damage caused
by the use of the ink cartridge replenished with ink.
• If the ink cartridge is moved from a cold place to a warm
place, leave it in the room temperature for three hours or
more before using it.
• Open the ink cartridge just before installing it in the machine.
If it is opened and left for an extended period of time, normal
printing performance of the machine may not be ensured.
• Make sure to store ink cartridges in a cool and dark place.
• Store ink cartridges and waste ink bottle in a place that is out
of the reach of children.
• Be sure to thoroughly consume the ink in the ink cartridge,
once it is opened, within three months. If an extended period
of time has passed away after opening the cartridge tank,
printing quality would be poor.
• Neither pound the cartridge nor shake it violently, as doing
so can cause leakage of ink.
• Do not touch or stain the contacts of the ink cartridge, as
doing so may cause damage to the print circuit board.
• Consult your sales or service representative for proper
disposal of ink cartridge, ink pack, and waste ink.
When you dispose them by yourself, follow the regulations
stipulated by the industrial waste disposer or the country or
region you live in
• Make sure that you shake the white
and silver
ink
cartridges before printing.
To Next Page
Loading...
