5-16
Replace the waste ink tank with
another
1
The warning message “Check waste ink”
is displayed.
2
Press the
(MAINT.)
key.
3
Check the state of the waste ink tank.
4
If the amount of waste ink needs to be
adjusted, press the key.
• Compare the amount of waste ink shown on the
display and the amount you visually confirmed. If
there is no major problem with the value shown
on the display, instead of the [ENTER] key, press
the [END] key and proceed to Step 6.
5
Press to adjust the level, and
then press the key.
6
Pull the waste ink tank stopper to open to
the front.
7
Pull it frontward to remove by holding the
waste ink tank handle.
8
Replace the waste ink tank.
(1) Prepare a new waste ink tank (SPC-0117).
(2) Insert the waste ink tank by holding a handle
of the tank.
9
Close the waste ink tank stopper.
10
Press the key.
• The ink discharging amount that is controlled by
the machine is reset and the message is
cancelled.
• Put a cap on the waste
ink tank removed.
• Waste ink is equivalent to waste oil of industrial
waste. Request an industrial waste disposal
company for disposal of waste ink.
To Next Page
Loading...
