MIMAKI CJV300-130 - System Halt Error Causes and Solutions

Chapter 6 Troubleshooting
6-12
SYSTEM HALT
There remains received data that has
not yet been printed.
• Execute the data clear function. ( P.2-26)
An error occurred in the mounted heads.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
The media width or the media length
required for printing is not enough.
• Change the media to the one with enough
width or length.
• When the media width narrows because the
origin moved, slide the origin to the right to
widen the effective media width.
An error occurred in the main PCB
FROM.
• Turn off the main power to the machine and
turn it on after a while.
• If the same error message appears again,
contact your local distributor to call for ser-
vice.
Message Solution
• Turn off the main power to the machine and turn it on after a while.
If the same error message appears again, check the number and contact your local dis-
tributor to call for service. (“000” is the error No.)
• Perform cleaning around the wiper.
• Turn off the main power to the machine and turn it on after a while.
If the same error message appears again, check the number and contact your local dis-
tributor to call for service.
Message Cause Solution
ERROR 902
DATA REMAIN
ERROR 90d
NO HEAD SELECT
ERROR 90f
PRINT AREA SHORT
ERROR 04
PARAM ROM
SYSTEM HALT (*)
000 : MESSAGE
SYSTEM HALT (*)
406 : WIPER ORG