AC inlet
Connect the power cable to the AC inlet.
Clamp lever (rear)
Interlocks with the clamp lever
in the font of this machine.
USB 2.0 connector
This is USB2.0 interface connector.
Main power switch (INLET 1)
Turns on/off the main power for this machine. Leave
the main power turned on to prevent ink clogging.
Blowdown fan filter
Suppress upward
floating of the ink mist
that occurs during
printing.
Vent filter box
Vents the ink mist that
occurs during printing.
Roll holders
Putting this into the paper core
(right and left) of a roll media, hold
the media. It supports the paper
core of 2 inch and 3 inch.
Power switch for heater (INLET 2)
Turns on/off the heater for this machine.
LAN connector
Please use this connector when you use netwark
To Next Page
Loading...
