2-8
Maximum Print Area/Cut Area
The maximum printed area/cut area varies, depending on the position of the pinch roller( P.2-8 to P.2-7) and the origin
position ( P.2-14). The white area shown in the following figure represents the maximum print/ cut area.
The area other than that is the dead space that cannot be printed/cut.
Notes When Using media Holder
Setting Position of the Media
Set the media so that the right end of the media will be inside the area shown below.
The End of the Media Should Not Exceed the Slit Line on the Platen
CJV300-130 CJV300-160
Maximum printing/cut width 1361mm 1610mm
• If the is set with its end exceeding the slit line on the platen, the media may be lifted when it is fed obliquely. This may
cause damage to the head.
Set the media so that the right end of the media will be inside the
area shown by an arrow. (up to the 3rd grid roller from the right
end in front of the main body)
Media
Media press
Slit line
To Next Page
Loading...
