2-10
9
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the front of this
machine.
(3) Pull out the roll media gently and then stop
pulling when locked lightly.
10
Make the roll media even then lower the
clamp lever.
• Pulling several positions of the media lightly,
Lower the clamp lever after confirming that the
amount of the roll media pulled out is almost
even.
11
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• you do not need to use the media holder for
cutting.
12
Set an empty core of the roll media on the
take-up device.
13
Press the key to select “ROLL” .
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance
function is “ON” ( P.3-10), the screen for
entering media remaining amount is displayed
after detecting the media width.( P.2-11)
• When installing the media, align the media’s right
edge with the slit line in the platen. Placing the
media rightward of the slit line will make it rise up
if it moves obliquely, and this could cause
damage to the head.
• If a media is misaligned to the right/left more than
fixed position, a error message “MEDIA SET
POSITION R” is displayed. Set the media again.
To Next Page
Loading...
