2-11
2
2
2
2
2
14
Secure the media on the take-up device.
(P.2-12)
(1) Feed the media up to the core of the roll
media of the take-up device by pressing the
[] key.
(2) Fix the middle of the media with adhesive
tape.
(3) In the same manner, fix the left side and right
side of the media.
• Make sure that the there is no slack or
wrinkle on the media in such condition that
the roll media is pulled to right and left evenly,
and then stick the tape.
Setting the pinch roller pressure
After setting the media in place, set the pressure of the
pinch rollers that retain the media.
Be sure to set a pressure value that is appropriate for the
media.
With an inappropriate pinch roller pressure value, the
media could skew during printing or cutting, or the pinch
rollers could remain on the media after pinching.
1
Press the (PR 圧切替 ) key in LOCAL
mode.
2
Press the key, to select “PRINT” or
“CUT”.
• Now carry out setting of the pinch roller pressure
during printing and during cutting.
• The currently selected pinch roller pressure
(PRINT or CUT) is indicated by a “>” mark to the
left of it.
3
Press to select the pinch roller
whose pressure you are going to adjust.
4
Press , to adjust the pressure (L/
M/H).
5
Press the key.
6
Press , to end the setting.
• If you want to switch to another setting
immediately, press [<].
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is
“ON” (
P.3-10), the screen for entering media
remaining amount is displayed after detecting the media
width.
1
Display the screen for entering media
remaining amount.
2
Press to enter the media
remaining amount.
3
Press the key.
To Next Page
Loading...
