2-12
Take-up device
With the switch of the narrow take-up device, select the
take-up direction of the media or others.
Setting the torque limiter
The take-up device is provided with a torque limiter.
The take-up torque can be adjusted with the torque limiter.
(The torque limiter is set to "media" at delivery.)
If the tension is too strong to use a thin media of media,
lower the take-up torque with the torque limiter.
Clockwise turn :
Increases torque (a heavy and thicker media such as
tarpaulin or the like)
Counterclockwise turn :
Decreases torque (For light media)
When Not Using Taking-up Device
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Raise the clamp lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
Direction
selector
switch
UP
(REVERSE)
The take-up device winds the media
with the printed side facing in.
DOWN
(FORWARD)
The take-up device winds the media
with the printed side facing out.
ON/OFF button
Turns the winding motion on/off.
(Take-up operation is carried out for as
long as this switch is held down.)
ON/ OFF button
Direction selector
switch
50% of the maximum 100% of the maximum
Scale of the torque
Adjustment nut
• When performing printing or cutting of 700 mm or
more without using the taking-up device, evacuate
the takingup device to right and left. The quality of
the print and cut may become low because of the
impact when the front end of the media touches
the taking-up device.
To Next Page
Loading...
